I have just replaced the power window motors in my old Beast. Now, the next thing is the window channels/ seals. My question is how hard are they to replace?

What shoul I look out for? Is there a good write up out there for this job?

 

The ones around the vent wings suck.
The channel ones pop out with a screwdriver, and push back in easy, I use a little weather strip cement to hold them in.
Door panel wipers, and the wipers on the door skin have to be installed per instructions that come with them. usually they just clip, or pop rivet in

Door jamb rubber is usually held on with rubber stripping cement.
I haven't done any in a while, but I do have one truck here to be painted this summer, so I will shoot some pictures when I do the project